华南理工大学学报(自然科学版) ›› 2013, Vol. 41 ›› Issue (7): 68-74.doi: 10.3969/j.issn.1000-565X.2013.07.012

• 化学化工 • 上一篇    下一篇

改性蒙脱石稳定的ASA 乳液的性能与应用

于得海 林兆云 李友明   

  1. 华南理工大学 制浆造纸工程国家重点实验室,广东 广州 510640
  • 收稿日期:2012-12-03 修回日期:2013-01-09 出版日期:2013-07-25 发布日期:2013-06-01
  • 通信作者: 李友明(1957-),男,教授,博士生导师,主要从事纸浆造纸清洁生产技术、造纸化学品等的研究. E-mail:ymli3@scut.edu.cn
  • 作者简介:于得海(1982-),男,博士生,主要从事造纸湿部化学和胶体与界面化学研究.E-mail:kyo-@163.com
  • 基金资助:

    国家自然科学基金资助项目(20776055)

Properties and Application of ASA Emulsion Stabilized by Modified Montmorillonite

Yu De- hai Lin Zhao- yun Li You- ming   

  1. State Key Laboratory of Pulp and Paper Engineering,South China University of Technology,Guangzhou 510640,Guangdong,China
  • Received:2012-12-03 Revised:2013-01-09 Online:2013-07-25 Published:2013-06-01
  • Contact: 李友明(1957-),男,教授,博士生导师,主要从事纸浆造纸清洁生产技术、造纸化学品等的研究. E-mail:ymli3@scut.edu.cn
  • About author:于得海(1982-),男,博士生,主要从事造纸湿部化学和胶体与界面化学研究.E-mail:kyo-@163.com
  • Supported by:

    国家自然科学基金资助项目(20776055)

摘要: 利用硅烷偶联剂KH570 改性的蒙脱石固体颗粒乳化制备稳定的皮克林乳液型烯基琥珀酸酐( ASA) 造纸施胶剂,研究了pH 值、油水比和固体颗粒浓度对ASA 皮克林乳液稳定性及施胶性能的影响.结果表明: 改性蒙脱石明显改善了ASA 乳液的稳定性; 随着pH 值的增大,所制备的ASA 乳液的稳定性先升高后降低,pH 值为7.0 时乳液稳定性最高; 油水比达3∶1 时会发生转相,ASA 皮克林乳液由水包油( O/W) 型乳液转变为油包水( W/O) 型乳液; 固体颗粒浓度与油水界面处的固体颗粒膜以及连续相中固体颗粒网络结构的形成密切相关; 固体颗粒浓度越大,乳液粒径越小,乳液稳定性越好; 所制备的ASA乳液的最佳固体颗粒浓度为1.5% ~2.0%; 改性蒙脱石有效提高了ASA 乳液的水解稳定性,具有良好的施胶应用效果.

关键词: 硅烷偶联剂, 蒙脱石, 皮克林乳液, 乳化, 烯基琥珀酸酐, 施胶

Abstract:

Stable ASA Pickering emulsions were prepared by using montmorillonite clay- particles modified by silane coupling agent KH570 as the particulate emulsifier of ASA and water,and the effects of pH value,oil- to- water ratio and particle concentration on the stability and sizing performance of the emulsions were investigated.The results indicate that the presence of modified montmorillonite remarkably improves the stability of ASA emulsions,that the stability first increases and then decreases with the increase in pH value and reaches the maximum at pH 7.0,that a phase inversion from an oil- in- water (O/W) emulsion to a water- in- oil (W/O) emulsion may occur at a oil- to-water ratio of 3:1,that the particle concentration is tightly related to the formations of the particle film at oil- water interface and the clay particle network in water,that higher particle concentration results in smaller droplet size andhigher stability of ASA emulsions,that the optimal particle concentration for ASA emulsions ranges from 1.5% to 2.0%,and that both the stability to hydrolysis and the sizing performance of ASA emulsions greatly improve due to the employment of modified montmorillonite.

Key words: silane coupling agent, montmorillonite, Pickering emulsion, emulsification, alkenyl succinic anhydride, sizing