华南理工大学学报(自然科学版) ›› 2020, Vol. 48 ›› Issue (3): 55-66.doi: 10.12141/j.issn.1000-565X.180414

• 土木建筑工程 • 上一篇    下一篇

分离式竖向加劲板钢管混凝土柱 - 梁节点的抗震性能

黄海斌1,2 王彦超2 刘亚洲1 刘红军1   

  1. 1. 重庆大学 土木工程学院,重庆 400045;2. 杭州铁木辛柯建筑结构设计事务所,浙江 杭州 311200
  • 收稿日期:2018-08-18 修回日期:2019-04-22 出版日期:2020-03-25 发布日期:2020-03-01
  • 通信作者: 黄海斌(1979-),男,博士生,主要从事结构工程研究。 E-mail:94213202@qq.com
  • 作者简介:黄海斌(1979-),男,博士生,主要从事结构工程研究。
  • 基金资助:
    国家自然科学基金资助项目(51508054)

Seismic Performance of CFT Column-to-Beam Joints with Detached Vertical Stiffeners

HUANG Haibin1,2 WANG Yanchao2 LIU Yazhou1 LIU Hongjun1   

  1. 1. School of Civil Engineering, Chongqing University, Chongqing 400045, China; 2. Timoshenko Architecture Design Office, Hangzhou 311200, Zhejiang, China
  • Received:2018-08-18 Revised:2019-04-22 Online:2020-03-25 Published:2020-03-01
  • Contact: 黄海斌(1979-),男,博士生,主要从事结构工程研究。 E-mail:94213202@qq.com
  • About author:黄海斌(1979-),男,博士生,主要从事结构工程研究。
  • Supported by:
    Supported by the National Natural Science Foundation of China (51508054)

摘要: 为了研究分离式竖向加劲板钢管混凝土柱-梁节点的抗震性能,对7个节点试件进行了在柱顶施加恒定轴压力、梁端施加往复荷载的试验。通过对试验数据分析,得到了各个试件的荷载-位移曲线、骨架曲线、应变曲线、强度和刚度退化规律、延性等结果。试验观测到节点发生3种破坏模式:梁翼缘在加劲板短边附近受拉破坏;梁翼缘和加劲板间焊缝受剪破坏;与加劲板连接处的钢管壁受拉破坏。在屈服线理论的基础上,提出了与加劲板连接处钢管壁受拉破坏模式下的塑性机构模型。根据虚功原理推导出了该模式下的屈服荷载计算公式,计算公式与试验结果吻合较好。将推导出的公式与典型的3种破坏模式计算公式相组合,可以准确地预测节点最终破坏模式。

关键词: 钢管混凝土柱-梁节点, 往复荷载, 抗震性能, 屈服线理论, 屈服荷载

Abstract: In order to study the seismic performance of CFT column-to-beam joints with detached vertical stiffeners, 7 joint specimens were tested under constant axial compression at the top of the column and cyclic loads at the end of the beam. Through the analysis of test data, the load-displacement curve, skeleton curve, strain curve, strength and stiffness degradation laws, ductility and other results of each specimen were obtained. Three ultimate failure modes of the joints were found in the tests, namely, tensile failure of the beam flange near the short edge of vertical stiffeners, shear failure of welds between the beam flange and vertical stiffeners, and tensile failure of the steel tube wall connected with vertical stiffeners. Then a plastic mechanism model of the joints under tension failure mode of the steel tube wall connected with vertical stiffeners was put forward based on the yield-line theory. And the yield load calculation formula under this mode was derived according to the principle of virtual work. The calculated results are in consistent with the test results. Combining the derived formula with calculation formulas of three typical failure modes, the ultimate failure mode of the joints can be accurately predicted.

Key words: CFT column-to-beam joints, cyclic loads, seismic performance, yield-line theory, yield load