华南理工大学学报(自然科学版) ›› 2017, Vol. 45 ›› Issue (6): 109-116.doi: 10.3969/j.issn.1000-565X.2017.06.017

• 化学化工 • 上一篇    下一篇

TDI-TMP 预聚物的结构表征及反应动力学

钟理 张立 黄洪   

  1. 华南理工大学 化学与化工学院,广东 广州 510640
  • 收稿日期:2016-09-18 出版日期:2017-06-25 发布日期:2017-05-02
  • 通信作者: 钟理(1956-),男,教授,博士生导师,主要从事精细化工和环保化学工艺研究. E-mail:celzhong@scut.edu.cn
  • 作者简介:钟理(1956-),男,教授,博士生导师,主要从事精细化工和环保化学工艺研究.
  • 基金资助:

    国家重点基础研究发展计划(973 计划)项目(2016CB5151330)

Structure Characterization and Reaction Kinetics of TDI-TMP Prepolymer

ZHONG Li ZHANG Li HUANG Hong   

  1. School of Chemistry and Chemical Engineering,South China University of Technology,Guangzhou 510640,Guangdong,China
  • Received:2016-09-18 Online:2017-06-25 Published:2017-05-02
  • Contact: 钟理(1956-),男,教授,博士生导师,主要从事精细化工和环保化学工艺研究. E-mail:celzhong@scut.edu.cn
  • About author:钟理(1956-),男,教授,博士生导师,主要从事精细化工和环保化学工艺研究.
  • Supported by:

    Supported by the National Program on Key Basic Research Project of China(973 Program)(2016CB5151330)

摘要: 采用红外光谱、核磁共振、高分辨质谱对甲苯二异氰酸酯(TDI)与三羟甲基丙烷 (TMP)反应预聚物进行表征,并通过高效液相色谱 - 质谱联用追踪反应中各低聚物中间 体的含量,研究 TDI 和 TMP 的反应动力学. 研究表明:TDI-TMP 加成反应为二级反应;温 度对 TDI 中 2 位和 4 位—NCO 的反应选择性有显著影响,反应温度从 50℃升高到 80℃, 2 位—NCO 选择性从 0. 41 增加到 0. 64;在 80 ℃ 下,三步反应的反应速率常数分别为 0.18540、0.03789 和0.01140mol-1 ·L-1 ·min-1 ,活化能分别为 12. 76、16. 58 和 25. 63kJ/mol, 反应第三步较前两步对温度更加敏感,故反应后期适当提高温度有利于反应的充分进行.

关键词: 甲苯二异氰酸酯, 三羟甲基丙烷, 结构表征, 反应动力学, 高效液相色谱-质谱联用

Abstract:

FT-IR,NMRand high-resolution MS were used to characterize the chemical structure of toluene diiso- cyanate (TDI)-trimethylolpropane (TMP) prepolymer,and HPLC-MS was adopted to detect the concentration of each oligomer in the reaction intermediates and to further reveal the reaction kinetics of TDI and TMP.The results indicate that (1) the TDI-TMP addition reaction is a second-order reaction; (2) temperature significantly affects the reaction selectivity of 2'-and 4'-NCO in TDI; (3) the 2'-NCO selectivity increases from 0. 41 to 0. 64 when the temperature increases from 50℃ to 80℃; (4) the reaction rate constants of the three steps of the reaction at 80℃ are 0. 18540,0. 03789 and 0. 01140mol-1 ·L-1 ·min-1 ,respectively,with the corresponding activation energy be- ing 12. 76,16. 58 and 25. 63 kJ/mol,respectively; and (5) the third step of the reaction is more sensitive to temperature than the first two steps,so that appropriately raising temperature in the later reaction may result in a more sufficient reaction.

Key words: toluene diisocyanate, trimethylolpropane, structure characterization, reaction kinetics, HPLC-MS