华南理工大学学报(自然科学版) ›› 2020, Vol. 48 ›› Issue (12): 1-9.doi: 10.12141/j.issn.1000-565X.190803

• 动力与电气工程 • 上一篇    下一篇

基于SN补偿的无线输电系统的分析及原边控制

杨金明 邓梓颖 刘润鹏 孙杰杉   

  1. 华南理工大学 电力学院,广东 广州 510640
  • 收稿日期:2019-11-11 修回日期:2020-05-30 出版日期:2020-12-25 发布日期:2020-12-01
  • 通信作者: 杨金明(1962-) ,男,博士,教授,主要从事能源与动力系统中电力电子及其控制技术研究。 E-mail:jmyang@scut.edu.cn
  • 作者简介:杨金明(1962-) ,男,博士,教授,主要从事能源与动力系统中电力电子及其控制技术研究。
  • 基金资助:

    国家自然科学基金资助项目 ( 51177050)

Analysis and Primary-Side Control of Wireless Power Transfer System Based on Series-None Compensation

YANG Jinming DENG Ziying LIU Runpeng SUN Jieshan   

  1. School of Electric Power Engineering,South China University of Technology,Guangzhou 510640,Guangdong,China
  • Received:2019-11-11 Revised:2020-05-30 Online:2020-12-25 Published:2020-12-01
  • Contact: 杨金明(1962-) ,男,博士,教授,主要从事能源与动力系统中电力电子及其控制技术研究。 E-mail:jmyang@scut.edu.cn
  • About author:杨金明(1962-) ,男,博士,教授,主要从事能源与动力系统中电力电子及其控制技术研究。
  • Supported by:

    Supported by the National Natural Science Foundation of China ( 51177050)

摘要:

基于 SN ( 串联-无补偿) 的无线输电系统具有接收侧结构简单、在强耦合和 高品质因数的情况下效率较高的优点。为了解决因发射线圈和接收线圈之间的互感发生 偏移及负载变化引起的输出电压不恒定的问题,文中提出了一种原边检测控制方式,通 过测量发射线圈侧的输入电压、电流及二者之间的相角差来计算实际的互感和接收线圈 侧的输出电压,并在此基础上实现闭环控制。文中首先分析了基于 SN 补偿拓扑的系统 的原边检测原理以及系统的效率特性,然后采用 Simulink 仿真软件分别进行开环和闭环 的仿真来验证理论分析的正确性,最后通过实验验证该控制方法的可行性。仿真与实验 分析表明,文中提出的控制方式是正确、有效的。

关键词: 无线输电, 补偿拓扑, 原边控制

Abstract:

The wireless power transfer system based on SN ( Series-None compensation) has the advantages of high efficiency in the case of strong coupling and high quality factor as well as simple-structured receiver. In order to deal with the unstable voltage caused by mutual inductance shifting and load fluctuation,a primary side detection method was proposed. The actual mutual inductance and output voltage of the receiving side were calculated by measuring the input voltage and current of the transmitting side and the phase difference between them. The closedloop control was realized on this basis. In this paper,the principle of the primary side detection of the system based on Series-None compensation topology and the efficiency characteristics of the system were analyzed firstly. Then the theoretical analysis was verified by the simulations of open loop and closed loop respectively with Simulink simulation software. Finally,the feasibility of the control method was verified by experiments. Simulation and experimental analysis proves that the control method proposed in the article is correct and effective.

Key words: wireless power transfer, compensation topology, primary side control

中图分类号: