华南理工大学学报(自然科学版) ›› 2008, Vol. 36 ›› Issue (10): 20-24.

• 土木建筑工程 • 上一篇    下一篇

开矩形孔的钢筋混凝土梁的试验研究

黄泰赟 蔡健 陈静芬   

  1. 华南理工大学 土木与交通学院, 广东 广州 510640
  • 收稿日期:2007-10-08 修回日期:2008-02-12 出版日期:2008-10-25 发布日期:2008-10-25
  • 通信作者: 黄泰赟(1974-),男,博士生,高级工程师,现任职于广州珠江外资建筑设计院,主要从事结构设计研究. E-mail:ty.huang@163.com
  • 作者简介:黄泰赟(1974-),男,博士生,高级工程师,现任职于广州珠江外资建筑设计院,主要从事结构设计研究.
  • 基金资助:

    广东省自然科学基金资助项目(020965)

Experimental Investigation of Reinforced Concrete Beam with Rectangular Opening

Huang Tai-yun  Cai Jian  Chen Jing-fen   

  1. School of Civil Engineering and Transportation, South China University of Technology, Guangzhou 510640, Guangdong, China
  • Received:2007-10-08 Revised:2008-02-12 Online:2008-10-25 Published:2008-10-25
  • Contact: 黄泰赟(1974-),男,博士生,高级工程师,现任职于广州珠江外资建筑设计院,主要从事结构设计研究. E-mail:ty.huang@163.com
  • About author:黄泰赟(1974-),男,博士生,高级工程师,现任职于广州珠江外资建筑设计院,主要从事结构设计研究.
  • Supported by:

    广东省自然科学基金资助项目(020965)

摘要: 采用钢筋混凝土开孔梁是降低建筑层高的有效途径,但迄今仍缺乏对开孔梁系统的多参数试验研究.文中进行了20个腹部开设矩形孔的钢筋混凝土简支梁试件在集中荷载下的试验.结果表明:梁开设孔洞后,其抗剪承载力下降,其挠曲变形特点也不同于一般的实腹梁;孔侧配置加强箍筋和加强斜筋都可以提高开孔梁的抗剪承载力;当孔侧加强腹筋和弦杆的配箍足够大时,可避免梁发生剪压破坏;孔洞上方混凝土可视为偏心受压杆件,孔洞下方混凝土可视为偏心受拉杆件,两种杆件的杆中均存在反弯点.文中还提出了开矩形孔的钢筋混凝土梁的抗剪承载力计算方法.

关键词: 钢筋混凝土梁, 矩形孔, 受力性能, 抗剪承载力

Abstract:

One of the most effective methods to reduce the story height is to use reinforced concrete (RC) beam with opening. However, there is a lack of systematic multi-parameter experimental investigations of such beams. In this paper, 20 simply-supported reinforced concrete beams with rectangular openings were tested under concentrated load. Experimental results show that ( 1 ) the beam with rectangular opening is of a reduced shear capacity and special deflection deformation characteristics different from those of common beams; (2) both the strengthening stirrups and the bent-up steel bars at the opening sides improve the shear capacity of the beam; (3) the shear-compression failure can be avoided if the transverse reinforcements and the stirrups of chords are large enough; and (4) the concretes above and below the opening can be considered as an eccentric compressive component and an eccentric tensile one with anti-bending point, respectively. A prediction method of bear capacity of the RC beam with rectangular opening is also proposed in this paper.

Key words: reinforced concrete beam, rectangular opening, mechanical behavior, shear capacity